Brake Pipe Bender Specifications:
Handheld mini pipe bender designed for 6mm, 8mm and 10mm pipe.
Bends pipes smoothly and evenly without kinks in the pipe work.
Bends pipes from 0180 degrees. This also means if you are doing a 90 degree bend you can bend past a little bit to allow for the spring back of the pipe.
Suits pipe sizes 6mm, 8mm and 10mm. Will also bend the close imperial size pipes.
Total length 260mm (101/2″)
Flaring Kit Specifications:
Suitable for Steel, Aluminium, Copper, Brass, Kunnifer…
Flares pipes sizes; 3/16″, 1/4″, 5/16″, 3/8″, 7/16″, 1/2″ & 5/8″.
Can be used with the pipe in position on the car.
Professional tool for commercial or occasional use.
Creates both single and double flares.
Chrome plated hardened and tempered steel swivel for strength and durability as well as reduced friction.
Hardened centre punch and floating cone produce a 45 degree flare assuring a tight fit.
Seven flaring dies will accommodate all standard high pressure fittings and will not crush the tubing.
Flaring tool Steel compressor yoke
7 x Flaring dies
3/16″ / 1/4″ / 5/16″ / 3/8″ / 7/16″ / 1/2″ and 5/8″
Pipe Tube Cutter Specifications:
Aluminium Alloy Body
Tubing cutter for copper tubes, thin walled stainless steel tubes, thin walled steel, aluminium, brass tubes.
Small, handy, especially for hard to reach places.
Sturdy construction and hardened back pressure rollers provide exact alignment to the tube and long life.
Operating knob in metal for easy infeed and cutting.
Broad, precise cutter on hardened, non rotating axis guarantees rectangular section.
Specially hardened cutter wheel in approved, tough hard REMS die-steel ensures long service life.
Cutter wheel protected restricted to before touching the back pressure rollers.
3 22 mm
